Toshiba G7 - Manual (Page 17)

G7 ASD Multi-Protocol Communication Option and PG Feedback Option Manual 10
Pulse Input Type Characteristics
Type 2
Open Collector
Lower noise-immunity characteristics.
Need to pay attention to waveform irregularity and distortion.
Input circuit diagram:
6.4 PG Feedback Connection
The pulse input signals are connected to terminal block TB1. Table 3 provides terminal descriptions for
terminal block TB1. PGA1 and PGA2 are connected for Phase A, PGB1 and PGB2 are connected for
Phase B, and PGZ1 and PGZ2 are connected for Phase Z. The wiring for Phase Z is done only when
using a Z-marker is necessary. The polarity of the pulse input signals should be as follows:
+ Side: PGA1, PGB1, PGZ1
- Side: PGA2, PGB2, PGZ2
Table 3: Terminal description for TB1
Terminal
Number
Terminal
Name
Function Specification
1 PGA1
2 PGA2
PG feedback input,
Pulse train speed command input
(Phase A input)
3 PGB1
4 PGB2
PG feedback input
Pulse train speed command input
(Phase B input)
5 PGZ1
6 PGZ2
PG feedback input
Pulse train speed command input
(Phase Z input)
Selectable:
line driver / open collector
Maximum input frequency:
60kpps (2 phases)
120kpps (single phase)
Pulse duty cycle:
50 ± 10%
Minimum input current requirement:
2.5mA
7 PGVC
8 PGCC
PG power supply terminal
Selectable:
5VDC, 6VDC, 12VDC, 15VDC