TOA Electronics A-9120DH - Manual (Page 53)

53
U T I L I T Y R E M O T E
Function selection
(when the remote volume control
is selected) Remote controller type setting
(when the remote controller type
is set to VOLUME)
(p. 61-C26)
Remote-controlled channel setting* (p. 61-C27)
From the previous page
To the next page
U T I L I T Y A N C
Function selection
(when the ANC monitor is selected) ANC monitor switching ON/OFF
setting
(p. 62-C29)
U T I L I T Y E V E N T
Function selection
(when the Event activation at
power-on is selected)
(p. 55-C1)
(In the normal matrix operation)
A N C M O N S E L E C T = O N
Monitor switching control input terminal setting (p. 62-C30)
(When the ANC monitor switching is set to ON)
M O N S E L E C T C I N 0 1
Setting the Event to be recalled
when power is switched on
(p. 63-C34)
R E M O T E 1 V O L U M E
(when the remote controller type
is set to ZM-9001)
(p. 61-C26)
(when the remote controller type
is set to ZM-9002)
(p. 61-C26)
R E M O T E 1 Z M - 9 0 0 2 R E M O T E 1 Z M - 9 0 0 1
R E M O T E 1 O U T P U T 1
(When the remote-controlled channel is the output channel)
Volume-controlled signal setting
(p. 61-C28)
V A L I D F O R A L L
P O W E R O N – E V E N T L A S T U T I L I T Y C H A N N E L
Function selection
(when the input channel activation
at power-on is selected)
(p. 55-C1)
(In the 1-channel or 2-channel output operation)
Setting the input channel to be recalled
when power is switched on
(p. 63-C35)
P O W E R O N – C H L A S T
In the 1-channel output operation,
the selectable output channel is
Output 1 only. *
Interlock output control setting (p. 62-C31)
M O N S E L S Y N C O N
Interlock output terminal setting (p. 62-C33)
Monitored ANC input channel selection (p. 62-C32)
(When the interlock output control is set to ON)
(P. 55-C1)
S E L E C T S Y N C A N C 1
S E L E C T S Y N C C O U T 0 1
PARAMETER PARAMETER
or
PARAMETER
or
PARAMETER
or
PARAMETER