TurboChef Technologies High h Batch - Manual (Page 18)

10 OVEN MAINTENANCE
Deep Clean Procedures
Step 1: Prepare the Oven for Cleaning
†
Ensure oven is turned off. To turn off oven,
press
ON
/
OFF
key.
†
Ensure cool down process is complete. (“Cooling
Down” will disappear upon completion.)
WARNING: Injury can occur if oven is not
allowed time to cool properly before clean-
ing. DO NOT attempt to clean it until the
“Cooling Down” message is off.
Step 2: Clean and Remove the Oven Door
†
Open oven door.
†
Spray TurboChef Oven Cleaner to break up
stubborn stains. Allow cleaner to penetrate for
5 minutes.
†
Scrub with nylon scrub pad, if necessary.
†
Wipe down the oven interior.
†
Rotate hinge retainers to unlocked state.
See Figure 8.
†
Raise oven door so it rests on hinge retainers.
†
Remove the door for easier access to components.
Step 3: Remove Oven Rack
†
Wash, rinse, and sanitize the oven rack.
Step 4: Remove Bottom Jetplate
†
For instructions, see page 7.
†
Wash, rinse, and sanitize the jetplate and
support rails.
Step 5: Check Grease Filters
†
Check to see if filters are clogged with debris. If
they need to be replaced, call your Authorized
Distributor (reference part number HHB-8114).
†
If necessary, remove filter by first unhooking the
filter clip (HHB-8115), which is attached at the
center of the Air Diverter Plate. See Figure 7.
Step 6: Clean the Cook Cavity and Drain System
†
Spray TurboChef Oven Cleaner to break up
stubborn stains. Allow cleaner to penetrate for
5 minutes.
WARNING: Never spray Oven Cleaner or
Guard directly onto the back oven cavity
wall. Doing so can damage critical components.
†
Scrub with nylon scrub pad, if necessary.
†
Open the drain lid and use water to flush out
food particles into the drain pan.
†
Close the lid when finished.
Step 7: Dry Cook Cavity and Drain System
†
Using a clean dry towel, dry the cook cavity and
drain system.
Step 8: Remove the Drain Pan
†
Wash, rinse, and sanitize the drain pan.
Step 9: Reattach/Reinstall all Clean Components
Step 10: Wipe Down the Outside of the Oven with a
Clean, Damp Towel
WARNING: Never spray Oven Cleaner
into any opening in the oven (for example,
the louvers in the side panels or the cooling fan
openings on the back panel). Doing so will damage
critical electrical components and result in a non-
warranty service call.
Step 11: Apply Oven Guard
†
Spray Oven Guard on a clean towel and apply
to oven interior.