TurboChef Technologies High h Batch User Manual

Page 13

Built-In Installation (Figure 3)

TurboChef ovens are designed to be installed on a

countertop or table. They are not intended for

built-in or enclosed installation.

“Built-in or enclosed installation” is defined as

installing an oven in any structure that surrounds

the oven by five sides (i.e., top/rear/side panels and

base).

If installation must be “built in,” the operator

must ensure the following:

Minimum of 300 cfm (8.5 cmm) of supplement

flow within the cabinet.

Minimum clearances of 2′′ (51 mm) to every

surface.

In addition, the operator will be responsible for

compensating any extra time required to service

the product due to removing the product for

serviceability.

2.0" (51mm)

1: Must be included by contractor

4.0" (102 mm)

300 CFM (8.5 CMM)

Discharge to Ambient

Fan

2.0" (51mm)

Unobstructed
Airflow

Notes:

F I G U R E

4: Installation Near Open Heat Source

F I G U R E

3: Built-in Installation

THEORY OF OPERATION, SPECIFICATIONS, AND INSTALLATION