Oki PRINTING SOLUTIONS MULTIFUNCTION PRINTER CX2633 - Manual (Page 47)

Configuring Your Machine > 47
Print Setup
(cont.) Print Menu
(cont.) Printer Adjust
(cont.) BG Setting:
-3, -2, -1, 0, +1, +2,
+3 To correct variations in print
results caused by temperature/
humidity conditions and difference
in print density/frequency.
Change the setting when
background is dark.
Print Position
Adjust Front X Adjust:
-2.00~0~+2.00 mm
Front Y Adjust:
-2.00~0~+2.00 mm
Back X Adjust:
-2.00~0~+2.00 mm
Back Y Adjust:
-2.00~0~+2.00 mm X adjust: Adjusts the position of
the whole printing image
perpendicular to the direction of
paper movement (i.e.
horizontally).
Y adjust: Adjusts the position of
the whole printing image parallel
to the direction of paper
movement (i.e. vertically).
Drum Cleaning OFF, ON Set to produce idling of a drum
before printing in order to reduce
horizontal white lines. This
shortens image drum life.
Hex Dump OFF, ON Prints out the data received from
the host PC in hexidecimal code.
Color Menu Density Control Manual, Auto If set to Auto, image density will
be automatically adjusted at
power on, when a new image
drum or toner cartridge is
installed, and at intervals of 100,
300 and 500 drum counts. If a 500
drum count interval occurs during
a print job it will occur at the end
of that job, and will take up to 55
seconds. If set to manual, this
adjustment will only be performed
when initiated by the next menu
item.
Adjust Density Execute Press Yes to execute or No to
cancel.
Selecting this will perform the auto
density set up immediately.
Color Tuning/
Print Pattern Execute Press Yes to execute or No to
cancel.
Selecting this item prints the color
tuning pattern to help you adjust
the color balance.
FEATURE OPTION DESCRIPTION