Omron NT-series Programmable Terminal V022-E3-1 - Manual (Page 89)

Reference
Reference
[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance Mode
[ MAINTENANCE MENU ]
Quit
PT Setting Status
I/O Check
Display History
Memory Init.
Memory Switches
[ MEMORY INITIALIZATION MENU ]
Quit
Screen Data Memory
Memory Tables
Display History
Memory Switches
%/ .
Section 3-4
Selecting “No” will cancel the memory initialization. To change the system set-
tings or to register the screen data, set DIP SW2-1 to OFF and start the
NT600S, and then, call the System Menu screen.
The NT600S DIP SW2-1 is used to set “Screen data forced initialize effective/in-
effective”. Setting this to ON selects “effective”, and OFF “ineffective”.
Initialization of the Memory Tables
It is possible to initialize the numeral memory tables and character-string memory
tables in the NT600S. When these tables are initialized, the values are returned to
those set by the support tool.
If a memory table is initialized in the Maintenance Mode, it is initialized regardless
of the setting for the resume function (resume function: page 98)
If “Effective” is set for the “Resume Function” memory switch, the initial values set
with the support tool will not be reflected in the present values of the memory tables
unless the memory tables are initialized.
If “Ineffective” is set for the “Resume Function” memory switch, the memory
tables can be initialized just by switching the NT600S power off and back on again,
or by resetting it, (page 98)
Using the System Menu, initialize the memory tables by following the procedure
given below.
Select “Maintenance Mode”.
Select “Memory Init.”.
Select “Memory Tables”.