Setting the driver, Cautions when using the pcr – Roland PCR-80 User Manual
Page 32
32
Installing & Setting Up the Driver (Macintosh)
■
Setting the driver
1
Use the
USB cable
to connect the
PCR-30/50/80
to your
computer
.
1. With the power switch turned
OFF
, connect the
AC adaptor
to the
PCR-30/50/80
.
2. Connect the
AC adaptor
to an electrical outlet.
3. Use the
USB cable
to connect the
PCR-30/50/80
to your
computer
.
2
Set the PCR-30/50/80’s
power switch
to the
ON
position.
3
Make MIDI device settings on your sequencer software. For details on the
MIDI OUT/IN device
to select, refer to
“About the ports when using a USB
Cautions when using the PCR
Before you use your sequencer software, please note the following points.
* Connect the PCR-30/50/80 to your computer via a USB cable before you start up your sequencer or other
software.
* Do not disconnect the USB cable from the PCR-30/50/80 while your sequencer or other software
is running.
* Disconnect the USB cable from the PCR-30/50/80 only after you have quit your sequencer or other
software.
* Leave the Sleep function of your Macintosh turned off.
* The PCR-30/50/80 will not work in the Classic environment of Mac OS X. Use the PCR when the Classic
environment is not running.
For details on MIDI device
settings, refer to the
owner's manual for the
software you are using.
This completes the series of steps needed to connect the PCR-30/50/80 to the
Macintosh, install the MIDI driver, and make the driver settings.