Roland PCR-80 - Manual (Page 26)

26
Installing & Setting Up the Driver (Macintosh)
3
Double-click the PCR Driver-E Installer icon (found in the Driver E (Mac
OS 9, 8) folder of the CD-ROM) to start up the installer.
4
Verify the Install Location , and click [Install] .
fig.3-2_40
5
If a message like the following is
displayed, click
[Continue] .
The other currently running
applications will exit, and
installation will continue.
6
A dialog box will indicate Installation completed .
Click [Restart] to restart your Macintosh.
■ Setting the driver
OMS settings
1
Use the USB cable to connect the PCR-30/50/80 to your computer .
1. With the power switch turned OFF , connect the AC adaptor to the
PCR-30/50/80 .
2. Connect the AC adaptor to an electrical outlet.
3. Use the USB cable to connect the PCR-30/50/80 to your computer .
2
Set the PCR-30/50/80’s power switch to the ON position.
fig.3-3
3
From the CD-ROM, drag the Driver E (Mac OS 9, 8) -
OMS Setting folder to the hard disk of your Macintosh to
copy it.
fig.3-4
4
In the Opcode-OMS Application folder where you
installed OMS, double-click OMS Setup to start it up.
Once the connections have
been completed, turn on
power to your various
devices in the order
specified. By turning on
devices in the wrong
order, you risk causing
malfunction and/or
damage to speakers and
other devices.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
before the unit will operate
normally.