Roland PCR-80 - Manual (Page 25)

25
Español
Italiano
Français
Deutsch
English
Installing & Setting Up the
Driver (Macintosh)
Mac OS 9/8 users
■ Installing the driver
Use either OMS or FreeMIDI as the MIDI driver.
The included PCR driver is an add-on module for using the PCR-30/50/80
with OMS or FreeMIDI.
* Either OMS or FreeMIDI must be installed in your Macintosh, as appropriate
for the sequencer software you are using.
* Disconnect the PCR-30/50/80 from the Macintosh before you perform the installation.
Use the following procedure to install the PCR-30/50/80 driver.
1
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to exit this as well.
2
Prepare the CD-ROM.
Insert the CD-ROM into the CD-ROM drive.
The installation procedure will differ depending on your system.
Please proceed to one of the following sections, depending on the system you use.
• Mac OS 9/8 users ................................................. (p. 25)
• Mac OS X users ..................................................... (p. 31)
OMS can be found in the
OMS 2.3.8 E folder within
the OMS folder of the
CD-ROM. If you would
like to know more about
OMS , refer to
OMS_2.0E_Mac.pdf
which can be found in
the same folder.
If a PCR-30/50/80 is already connected to your Macintosh when you install the driver, a message
like the following will appear when the Macintosh is started up. Perform the steps described below
as appropriate for the message that is displayed.
If the screen indicates:
“Driver required for USB device ‘unknown device’ is not available. Search for driver
on the Internet?” ➔ click [Cancel] .
If the screen indicates:
“Software required for using device ‘unknown device’ cannot be found. Please refer
to the manual included with the device, and install the necessary software”.
➔ click [OK] .