Roland PCR-80 User Manual
Page 145
145
Edit mode (EDIT)
13. To specify “2” for the upper bits, press the
[2]
key.
The display will indicate “2BL”.
14. Confirm what’s indicated and press
[ENTER]
.
15. In the same way, enter bytes 8.
16. Since the ninth byte is the data area, press the
[DATA]
key.
The display will indicate “DT0.”
17. Confirm what’s indicated and press
[ENTER]
.
18. Since the ten byte will contain the checksum, press the
[CHECKSUM]
key to specify the location at which the
checksum will be input.
The display will blink “CS1” (Checksum Type 1).
19. Confirm what’s indicated and press
[ENTER]
.
20. Press the
[F]
and then
[7]
keys to input the ending status “F7.”
21. Confirm what’s indicated and press
[ENTER]
.
22. Next, specify an upper limit value of “58” for the data area.
23. Press
[ENTER]
.
24. Specify a lower limit value of “40” for the data area.
25. Press
[ENTER]
.
26. Specify the output port.
(➔
27. If you are making an assignment for a button, specify the button mode. (➔
The GS Bend Pitch Control message has been assigned.