Revox Recontrol M207 - Manual (Page 58)

Chapter 4 Menus
55
Motion
1. The Motion Detector will sense any movement and turn on
the LCD automatically.
2. You can use the function to change the sensitivity of Motion
detector. (Off/ Slow / Medium / Fast).
3. Please use or to change to sensitivity of Motion
Detector.
4. The more sensitive (eg:Fast), the more easily for the
Re:control M207 to turn on its LCD.
5. You can use the function to change the consumption of
electricity.
6. Please press to save your setting or press to exit
without saving the setting.
Welcome Page
1. There will be a welcome page when you first time use the
Re:control M207 or reset it.
2. Please use or to decide if you can see the
welcome page. (Enable/ Disable)
3. Please press to save your setting or press to exit
without saving the setting.
Calibrate
1. Please use “Calibrate” to adjust the accuracy of LCD when
you find the Re:control M207 is not so sensitive as before.
2. When you are calibrating the LCD, please press the place
where a sigh “X” shows up.
3. Please refer to Chapter 5.5 for detailed information or press
to exit without saving the setting.
Reset
1. When you want to reset your Re:control M207, please use
the function. It will erase all your settings in your remote.
2. There will be a message to confirm your decision. If you
really want to reset your remote, please tap “Yes”. Then you
will reset it right away.