3 device setting – Revox Recontrol M207 User Manual

Page 21

Re:control M207 User’s Manual

2.3 Device setting

1. Turn on the targeted device for the Re:control M207 to setting the

device.

2. The Re:control M207 will directly get throw the setup mode when

you operate the Re:control M207 at first time. Please tap the

target device key in the Main Menu to enter “Setup device” menu.

(ex. “TV” device)

* Pre-code: load pre-programmed IR code from the factory

default (no guarantee being able to control all brand

devices).

3. Pressing the

buttons to choose “Yes” item and

press

button for entering the operation mode.

4. Choose the first letter of targeted device brand (ex. n “S” on

behalf of Sony, Samsung…etc ), and point the Re:control
M207 at the targeted device, and then tap

o soft button

to start auto searching.

5. As you see the targeted device has been turned off, please tap

or press any buttons to stop auto searching right away. Tap

p gently to figure out the correct remote code

(Code number as shown on the top middle position of the

LCD.) till the targeted device has been turned on again. Press
the power key or the hard key to test the codes to confirm the

code. If the codes aren’t correct please continue repeat step

4-5 again to search the proper code for your target device.

6. Finally, press

button to load the code and exit.