Revox Recontrol M207 - Manual (Page 38)

Chapter 3 How to Set Your Re:control M207
35
6. Please select the brand of your device. You just need to select the
first letter of your brand. For example, if your device belongs to Sony,
please select “S” as your brand n.
In this page, you will find out an icon . It is
“Key Pad Entry” function. You can key in the
code number for your device directly. In this way,
you are able to save the time to load the
corresponding codes. However, each brand may
have several remote codes. You may need to
load the remote codes for some times to find out
the correct codes for your device.
or
7. After selecting “Brand” itemn, please make sure that the device is
turned on.
8. Please have the Re:control M207 pointed at your device and tap
osoft button to start auto searching.
9. When the Re:control M207 finds out the correct remote code for your
device, your device will be turned off. Please tap or press any button
on the Re:control M207 to stop auto searching.
10. Please press or p key to ascertain that the remote
codes are suitable for your device. Press the power key or the hard
key to test the codes to confirm the code. If the codes aren’t correct
please continue repeat step 4-5 again to search the proper code for
your target device.
11. If they work, it means that you have already found the correct remote
codes. Please press button to confirm your decision.
If they don’t work, please continuing the auto search by repeat the
step 8 ~ step10. After the Pre-code auto search are finished the LCD
will shows up the “Search completely” message and the “OK” icon.
Tap the “OK” to exit the auto search. This means this IR codes