Revox Recontrol M207 - Manual (Page 42)

Chapter 3 How to Set Your Re:control M207
39
press the specific key on your original remotes for about 2-3 seconds
until the symbol shows up on LCD.
7. The symbol will show up when the Re:control M207 learns
remote codes successfully. However, the symbol will show up
when the Re:control M207 fails to learn the remote codes. Please
repeat step 5. to learn the remote code if the Re:control M207 fails to
copy it.
8. Please press the button when you finish learning all keys.
learning successfully Learning fail
The preset layout for your device may not match
your original remote completely. Please use
“
Add Key” (Page 26) and “Delete” (Page
33) functions to adjust the layout.
3.9 Learn a Cycle key
Some devices save a circle of commands in one button. For the special
design, the Re:control M207 is equipped the Cycle function. With the
function, you are able to send the circle of commands.
1. Please press the
button for 1 second to enter Setup Menu. And
then enter “Code Setting” menu.
2. Please choose the “ Cycle” item and then press the button
to enter the submenu.