Setting up your tv – RCA HT35713BD User Manual
Page 5
8:27
S-VIDEO 90
Antenna: A
Cable/Air: Cable
VCR 1 Chan: 91
VCR 2 Chan: 92
Cable Chan: 90
3
4.
Press
+
to enter channel 91 for
VCR1 Chan
.
¥Laserdisc player: Repeat the above steps, substituting
VCR2 Chan
and pressing
9,
then
2,
for channel 92. Then press + to enter the channel.
¥Satellite Receiver: Repeat the above steps, substituting
Cable Chan
and pressing
9,
then
0,
for channel 90. Then press + to enter the channel.
Mute
Video Menu
Audio Menu
Setup Menu
Autoprogram
Chan Mem: Stored
Antenna: A
Cable/Air: Cable
VCR 1 Chan: Off
To Set Up TV Channels for VCR, Laserdisc Player, and Satellite Receiver
To have your TV automatically turn on and tune to the proper channel for viewing the
VCR, Laserdisc player, or satellite receiver when you press the corresponding button on the
remote, set up the channels as explained below. When properly programmed the following
will happen:
¥ Pressing
VCR1
on the remote will turn on the VCR, audio/video receiver, and TV, and
tune the TV to channel 91 to view the picture from the VCR.
¥ Pressing
VCR2•LD
on the remote will turn on the Laserdisc player, audio/video
receiver, and TV, and tune the TV to channel 92 to view the picture from the
Laserdisc player.
¥ Pressing
DSS•CABLE
on the remote will turn on the satellite receiver, audio/video
receiver, and TV, and tune the TV to channel 90 to view the picture from the
satellite receiver.
1.
Press
TV
on the remote to turn on the TV and audio/video receiver. Select an active
channel on the TV. Adjust the volume, if necessary.
2.
Press
TV MENU
on the remote until
Setup Menu
is highlighted. Press the
+
button or
–
on
the remote to display the setup functions, and then repeatedly press
TV MENU
to select
VCR1 Chan
function.
3.
Press
9
, then
1
, to tune the TV to channel 91 Ñ this is the channel to which the TV
will tune automatically when you press the
VCR1
button on the remote.
8:27
Input 1 91
Autoprogram
Chan Mem: Stored
Antenna: A
Cable/Air: Cable
VCR 1 Chan: 91
Setting Up Your TV
(Continued)
Note:
If you enter the wrong numbers, press the number buttons to enter the correct number.