RCA HT35713BD - Manual (Page 15)

13
Programming Your Remote
You can program the universal remote to control most brands of remote controllable TVs,
VCRs and cable boxes. If you have an RCA, GE or ProScan component, you may not need
to program the remote at all. Other manufacturersÕ brands will need to be programmed.
Programming the Remote to Control Other Brands of Components
To determine whether you need to program the universal remote, turn on the component
you want to operate, point the remote at the componentÕs remote sensor and press the
corresponding component button. Then, press the buttons
(VCR1, DSS•CABLE, VCR2•LD,
CD, AM•FM, TAPE) that will be used for that component to see if it responds to the remote
commands. If not, you need to program the remote.
Follow these steps to program your universal remote:
1 . Turn on the component.
2 . Look up the brand and code number(s) for the type of component you are
programming in the code lists on the next pages or on the code sheet packed
with your remote.
3 . Press and hold the component button on the remote.
4 . While holding the component button, enter the three-digit code from the
code list.
5 . Release the component button, then press one of the commonly used buttons
for that component to see if the component responds to the remote commands.
6 . Repeat steps 3 through 5 using the next code listed for your brand until the
component responds to the remote commands.
Programming Your Remote
Note: There may be some functions on the remote that will not operate on another brand of
component. Try several buttons to see if it is programmed correctly.
Programming the AUX Button
The AUX button can be programmed like an existing component button for a second TV, third
VCR, second satellite receiver, or additional audio components.
Follow these steps to program the AUX button:
1 . Turn on the component you want to program.
2 . Look up the brand and corresponding code number(s) in one of the code lists on the
previous pages.
3 . Press and hold the AUX button on the remote. Then, press the other component
buttonÑ AM/FM , TAPE , CD , DSS•CABLE , etc.
4 . Release the component button, but not the AUX button.
5 . Enter the three-digit code from the code list.
6 . Release the AUX button, then press the POWER or CHAN up or down to see if the
component responds to the remote commands. If it doesnÕt, press AUX , then
POWER again.
7 . Repeat steps 3 through 6 using the next code listed for the brand of your component
until it responds to the remote commands.