RCA hd52w59 - Manual

FOR FACTORY USE ONLY
CABLE
Off-air antenna for DIGITAL broadcasts
Regular cable outlet
OR
Off-air antenna for
regular (ANALOG) broadcasts
Tip:
If you need help deciding what
type of antenna to use, go to
antennaweb.org. By entering
where you live, this mapping
program tells you what local
analog and digital stations are
available to you.
Quick Start , , Guide
Connecting Your HDTV
Find the back panel of your HDTV, and connect your antennas or
regular analog cable wall outlet.
Important:
Do not connect the ANTENNA
DIGITAL INPUT jack to a digital
cable signal.
The fi rst time you turn on your TV, the Initial Setup screens appear automatically. This setup routine
guides you through the following steps to set up your HDTV:
•
Set the Menu Language
• Complete Channel Search .
Note: Make sure you have signals connected to both the ANTENNA DIGITAL INPUT and the ANTENNA/CABLE
ANALOG INPUT jacks on your HDTV before you perform the channel search on both sources.
• Change the Channel List and Channel Labels
Note: Changing Lists and Labels can be time consuming. You can change these later through the Setup menu.
• Run the Automatic Convergence
Note: For best results, repeat the Auto Convergence function (from the Setup menu) once the HDTV’s been running
for an hour. You can access Auto Convergence in the Setup menu (see the User’s Manual for more information).
Setting Up Your TV
Watching TV...
Now you’re ready to watch TV! Your TV has two tuners: one for analog TV channels and one for off-air digital channels.
To see which tuner you’re on: look at the channel number that appears in the bottom left corner of your screen when
you change channels—a ‘D’ appears next to the channel number on the digital tuner, while an ‘A’ appears next to the
channel number on the analog tuner.
To switch between the tuners: press the ANT•CAB or ANTENNA button on your remote.
To tune directly to a regular channel: enter the channel number and press OK.
Digital channels can have both primary channels (like the analog channel number) and subchannels. These subchannels might
offer programming that’s different from the primary channel.
NOTE: Not all digital channels offer subchannels.
To tune directly to a digital subchannel: make sure you’re on the digital tuner; then, enter the primary channel number,
press the right arrow button, enter the subchannel number, and press OK.
TOCOM 16556340
Note: This back panel illustration is for representation
only. Your back panel might be different.
continues inside...
16556340.indd 1 3/29/05 15:59:43