RCA HT35713BD - Manual (Page 26)

24
VCR PLUS+* Recording
Make sure the VCR has been set up for VCR Plus+ programming. See VCRÕs UserÕs Guide.
1. Press VCR1 on the remote to turn on the VCR, audio/video receiver, TV, and tune the TV
to channel 91 (Input 1). This also sets the remote to control the VCR.
VCR MAIN MENU
1 VCR Plus+ Programming
VCR PLUS+
Enter Plus Code number
(from TV listing)
-
How often should this
program record?
1 One time
2 Daily (every day)
3 Weekdays (Mon - Fri)
4 Weekly (once/week)
PROGRAM 1 - ONE TIME
Channel 08 CABLE
Start Time 02:10 PM
End Time 03:35 PM
Start Date 11/21/94 Mon
Tape Speed SLP
Press CLEAR to correct
Press MENU to save
2 . Press MENU PROGRAM on the remote to display the
VCR MAIN MENU .
3 . Press 1 to display the VCR PLUS+ menu.
4 . Press numbers on the remote to enter the PlusCode* number for
the program you want to record. VCR PlusCode numbers are
found in most local TV listings.
Press
CLEAR on the remote to correct an entry.
5 . Press MENU PROGRAM to enter the program.
If the VCR does not recognize the PlusCode number,
Unrecognized number... Please re-enter appears on the TV
screen
. Check the number and enter it again.
6 . Press 1 , 2 , 3 , or 4 to select type of program.
1 One time Ñ single program recorded once.
2 Daily Ñ program recorded at same time every day.
3 Weekdays Ñ program recorded at same time Monday
through Friday.
4 Weekly Ñ program recorded at same time once a week.
7 . Select recording speed using the SPEED button on the VCRÕs
remote or VCR.
8 . Optional: You may extend the recording time of VCR Plus+
programs. This option may be useful when recording programs
such as sporting events that could go past scheduled broadcast
times. To change the programÕs
End Time , press CLEAR
repeatedly to erase the program End Time , then enter the
new time.
9 . Press MENU PROGRAM to enter your program. A reminder appears which will time out
or you can press MENU PROGRAM to return to the VCR MAIN MENU.
PROGRAMS OVERLAP may appear on the screen if you entered two programs where the
times overlap.
10 . Repeat steps 2 – 9 for additional programs or press MENU PROGRAM to remove the
menu from the TV screen.
11 . Turn off the VCR before the recording is scheduled to begin. TIMER appears in the
VCRÕs display panel when the timer has been programmed.
Stopping a VCR Plus+ Recording in Progress
1. Press VCR1 and then STOP within a few seconds on the remote or press POWER and
then STOP within a few seconds on the VCR.
*VCR Plus+ and PlusCode are trademarks of Gemstar Development Corporation.
Using Your VCR
(Continued)