Setting up your tv, To autoprogram tv’s channel memory, To add and erase channels from tv’s memory – RCA HT35713BD User Manual
Page 4
2
To Add and Erase Channels from TV’s Memory
1.
To add or erase a channel, repeatedly press
TV MENU
to highlight
Setup Menu
, and
then press
+
or
–
to display the setup functions. Repeatedly press
TV MENU
to
highlight the
Chan Mem
function.
2.
Press
CHANNEL up
or
down
(or the two corresponding number buttons on the
remote) to select the desired channel you wish to add or erase.
3.
Press the
+
button to add the channel to memory, or press the
–
button to erase the
channel from memory.
Chan Label
Parental Ctrl: Off
Chan Ctrl: Normal
Autoprogram
Chan Mem: Stored
Mute
Video Menu
Audio Menu
Setup Menu
Your TV must be programmed for the system to operate properly. If it was not programmed,
complete these programming functions.
For complete operating information on your TV, see the UserÕs Guide for your TV.
To Autoprogram TV’s Channel Memory
1.
Press
TV
on the remote to turn on the TV and audio/video receiver. Select an active
channel on the TV. Adjust the volume, if necessary.
2.
Press
TV MENU
on the remote repeatedly until
Setup Menu
is highlighted. Press
+
on the
remote once and then press
TV MENU
repeatedly until
Autoprogram
is highlighted.
3.
Press
+
to begin autoprogramming. The TV will first program all channels for
ANT A
input and then program all channels for
ANT B
input. (Do not press any buttons until the
TV has finished autoprogramming itself.)
Mute
Video Menu
Audio Menu
Setup Menu
Set Alarm
Chan Label
Parental Ctrl: Off
Chan Ctrl: Normal
Autoprogram
Set Alarm
Chan Label
Parental Ctrl: Off
Chan Ctrl: Normal
Autoprogramming
4.
When the TV is finished cycling, you can check to see which channels are in memory by
pressing
CHANNEL up
or
down
on the remote.
4.
Be sure channel 91 has been added for the VCR, channel 92 has been added for the
Laserdisc player, and channel 90 has been added if an optional satellite receiver is
being used. Repeat steps
1-3
to add these channels. This lets you access these video
inputs as regular channels when you press
CHANNEL up
or
down
.
Setting Up Your TV
Chan Label
Parental Ctrl: Off
Chan Ctrl: Normal
Autoprogram
Chan Mem: Erased