Ricoh FAX5600L - Manual (Page 79)

2. Press ↓ until " TTI ON OFF "is displayed.
If you wish to change the TTI setting, press ← or → until the displayed
setting is correct.
3. Yes when you have finished.
ID Transmission
You must have stored an ID Code before you can use this feature; see page 85.
If you switch ID Transmission on, transmission will only take place if the other
terminal’s ID Code is the same as yours. This feature can stop you from
accidentally sending information to the wrong place, if you co-ordinate ID Codes
with the other party.
This feature works in the same way as Closed Network. To enable Closed
Network, you must have it switched on by a service technician; it then stays on for
all communications until you have it switched off. However, you can use ID
Transmission for whichever transmissions you like. For receptions, ID
Transmission does not work; you will have to use Closed Network if you wish to
use this type of feature for your received fax messages.
ID Transmission may not be reliable when communicating with terminals
produced by another maker.
Cross-reference
ID Code: see page 85.
Closed Network: see page 121.
1. Press ↓
0 7
2. Press ↓ until " ID TRANSMIT ON OFF "is displayed.
If you wish to change the ID TRANSMIT setting, press ← or → until the
displayed setting is correct.
OPTION SELECT YES TO END
AUTO REDUCE ON OFF
TTI
R
O
U
T
IN
E
O
P
E
R
A
T
IO
N
ROUTINE OPERATION SENDING A FAX MESSAGE
65