Ricoh FAX5600L - Manual (Page 156)

If the RTI/CSI is not the same as any of those that you have programmed into this
feature, the incoming message will be printed on paper from the normally-used
cassette.
The number of RTI/CSI’s that you can store for use with this feature is 10. You
can use Wild Cards to extend the number of RTI/CSI’s that you can specify.
Note: If one of the senders changes their RTI/CSI, you have to change the
stored RTI/CSI also. Otherwise, messages from that sender will no longer
be sent to the required cassette.
Cross-references
RTI and CSI: see page 25.
Wild Cards: see page 144.
TCR: see page 185.
Programming the Specified Cassette Selection Feature
1. Function 6 0 2 2 2 2
7 6
❐ At this time, you can print a Specified
Cassette Selection List by pressing → Start .
2. Either:
❐ Store some RTIs/CSIs:
1 .
Go to step 3.
❐ View the RTIs/CSIs that you have
stored so far: 2 . Go to step 6.
3. Type in an RTI or CSI, then
press Yes .
4. Either:
❐ Store this RTI as a wild card:
Yes
❐ Otherwise:
No
CST SELECT SELECT
DEST. 6 PRINT LIST
1. RTI PROG 2. RTI NO TO CANCEL
DEST. 6 on the opposite display shows that
there are 6 RTIs/CSIs programmed so far. In
a new machine, you will see
DEST. 0 .
_
CST SELECT ENTER RTI/CSI
NO TO CANCEL
ABC _
CST SELECT NO TO CANCEL
DEST. 1/6 CLR: CLR
XYZ. CO.
DEST. 1/6 means that there are 6
RTIs/CSIs programmed so far, and the first
in the list is now displayed.
CST SELECT
STORE AS WILD CARD? YES . NO
XYZ. CO.
CST SELECT ENTER RTI/CSI
NO TO CANCEL
ABC
_
Label input and editing: see page 7.
RECEPTION ADVANCED FEATURES
142