Rockwell SoniCrafter DEVICENET 1771-SDN - Manual (Page 48)

Publication 1771-6.5.132 - June 2000
3-10 Hardware Setup
Connecting the Scanner to the DeviceNet Network
To connect to the DeviceNet network:
1. Connect the DeviceNet drop line to the linear plug provided with
the scanner. Match the wire insulation colors to the colors shown
on the label.
2. Locate the DeviceNet port connector for Channel 1 on the front of
the module.
3. Insert the linear plug into the five-pin header for Channel 1.
ATTENTION
!
Do not wire your module with power applied to
your network. You may short circuit your network or
disrupt communication.
MODULE
STATUS
RESET
CHANNEL 1
NETWORK STATUS
NODE/ ERROR CODE
Device Net
CHANNEL 2
Device Net
NETWORK STATUS
NODE/ ERROR CODE
Front of
Scanner
Module
Module label shows
wiring color scheme
RED
WHITE
BARE
BLUE
BLACK
Dedicated DeviceNet
Drop Line
Channel 1 Port
Connector