3 - hardware setup, What this chapter contains, Installing the 1770-kfd interface module – Rockwell SoniCrafter DEVICENET 1771-SDN User Manual
Page 39: Chapter 3, Hardware setup, Chapter

1
Publication 1771-6.5.132 - June 2000
Chapter
3
Hardware Setup
What This Chapter Contains
This chapter describes how to set up the hardware for the example
application. The following table describes what this chapter contains
and where to find specific information.
Installing the 1770-KFD
Interface Module
Connect the RS-232 connector on the 1770-KFD interface module to
one of the serial ports on your PC workstation (e.g., COM1). Connect
the DeviceNet connector on the 1770-KFD module to a DeviceNet
drop or trunk cable. You can make this connection in several ways;
for example, using a DeviceNet Quad Tap (#1492-DN3TW), as shown
on page 3-13.
For detailed directions on how to install the 1770-KFD interface
module, see the DeviceNet RS-232 Interface Module Installation
Instructions, publication 1770-5.6.
For information about
See page
Installing the 1770-KFD Interface Module
Installing the PLC-5 Processor
Setting the I/O Chassis Backplane Switches
Going Online to the PLC-5 Processor
Installing the 1785-ENET Ethernet Module
Installing the 1771-SDN Scanner Module
Setting the Channel 1 Data Rate and Node Address Switches
Setting the I/O Chassis Addressing Node Switches
Installing the Scanner Module in the Chassis
Connecting the Scanner to the DeviceNet Network
Installing the RediSTATION Operator Interface
Installing the Series 9000 Photoeye
How Your Example System Will Look
to PC COM 1
1770-KFD RS-232
Interface Module
DeviceNet
Dropline or
Trunk Cable
More