Rockwell SoniCrafter DEVICENET 1771-SDN - Manual (Page 116)

Publication 1771-6.5.132 - June 2000
B-2 Installing and Configuring the ControlNet Communications Driver
These settings depend on the devices installed on your computer.
We used the following addresses:
When deciding which addresses to use, remember that each card in
your computer must have a unique base memory address and a
unique base I/O space memory address. If another card in the host
computer is using one or both of the selected addresses, you must
change the card’s switch settings to an available address.
3. Insert the card in a vacant 16- or 32-bit ISA/EISA expansion slot.
Configuring the 1784-KTCX15 Communications Driver
After installing the card in the computer, you must run RSLinx to
configure the driver.
1. Start RSLinx.
2. Select Configure Drivers from the Communications menu.
The following window will appear:
3. Select the Allen-Bradley 1784-KT/KTC(X) device from the
pull-down list and click on Add/New.
Base I/O Space Address 240
Base Memory Address D000:000 (factory default)
TIP
Consult with your IT/PC support group to find out
if it is necessary to change any of your computer’s
memory address or IRQ settings.