Ricoh AP305 - Manual (Page 62)

Installing the IPDL-C Printer Driver
32
4
Installing the Printer Driver Using Plug and Play
Preparation
Check to make sure that the printer is connected properly to your computer,
and that computer power is turned off.
A
Turn on the printer's power switch.
B
Turn on your computer.
Continue with one of the procedures below in accordance with what appears
on your computer's screen.
Note
❒ What happens after you turn on your computer depends on which version
of Windows 95/98 you are running and on your system setup.
❖ ❖ ❖ ❖ When the [New Hardware Found] dialog appears
The dialog indicates that plug and play is working. Continue with the pro-
cedure under P.32 “Plug and Play Installation 1”.
❖ ❖ ❖ ❖ When the [Device Driver Wizard] appears
This indicates that plug and play is working. Continue with the procedure
under P.33 “Plug and Play Installation 2” .
❖ ❖ ❖ ❖ When Windows 95/98 starts normally
This indicates that plug and play is not working. Continue with the proce-
dure under P.34 “Installing the Printer Driver Without Using Plug and Play”.
Plug and Play Installation 1
Use the following procedure to install the printer when the [New Hardware Found]
dialog appears after you turn on the printer and then your computer.
A
Insert the CD-ROM that comes with the printer, into your computer's CD-
ROM drive.
B
Click [Browse] .
The Windows 95/98 printer driver is on the following directory on the CD-
ROM: DRIVERS\IPDL_C\WIN95_98.
C
Select the CD-ROM drive using the [Drives] list box.
D
In the [Folders] box, double-click [DRIVERS] , [IPDL_C] and then [WIN95_98] . Fi-
nally, click [OK] .