Renesas Emulation Pod M3062PT3-RPD-E - Manual (Page 46)

M3062PT3-RPD-E User’s Manual 2. Setup
REJ10J0040-0600 Rev.6.00 July 01, 2006 Page 46 of 104
Table 2.4 Switch settings of the M3062PT3-RPD-E (2)
Signal Switch Setting Description
Xou
t
OP Xout
SW3
(factory-settings)
Does not connect pin Xout of the MCU to the user system.
Xout SW3
Xo
u
t
OP Xout
SW3
Connects pin Xout of the MCU to the user system.
P8
6/
Xc
ou
t
P86
/XC
OP
SW4
(factory-settings)
Connects pin P86/Xcout of the MCU to the user system to use it as
port P86 or Xcout.
P86/Xcout SW4
P86
/Xco
ut
SW4
P
86/
X
C
O
P
Does not connect pin P86/Xcout of the MCU to the user system.
P87/Xcin P87 Xcin
SW5
(factory-settings)
Connects pin P87/Xcin of the MCU as port P87.
P87/Xcin SW5
P87
/X
cin
P87 Xc
in
SW5
Connects pin P87/Xcin of the MCU as Xcin.
CAUTION
Note on Switch Settings:
z Always shut OFF power before changing switch setting.
IMPORTANT
Note on BYTE and CNVss Switch Settings:
z Switch settings of the BYTE and CNVss are for debugging without the user system connected.