Roland TD-6 - Manual (Page 104)

104
Chapter 7 Making the MIDI Settings (SETUP/MIDI, BULK DUMP)
5. Press [INC/+] or [DEC/-] to select the content to
be saved.
fig.07-027ai.e
6. Start the recording process of the external
sequencer.
7. Press [ENTER ].
Press [EXIT] to cancel the operation.
fig.07-028_50
8. Press [ENTER ] to start the data
transmission.
fig.07-029_50
9. When you have finished transmitting, the
Completed screen appears.
fig.07-030_50
10. Stop recording on the external sequencer.
Bulk Dump:
ALL, SETUP, ALL SONGS, ALL KITS,
KIT 01–KIT 99
ALL:
All data, including the setup (trigger, pad, and other such
settings), drum kits, and User songs are transmitted.
SETUP:
All setup data is transmitted.
ALL SONGS:
All data for User Songs 151–250 is transmitted.
ALL KITS:
All data for Drum Kits 1–99 is transmitted.
KIT 01–KIT 99:
Only the data for the selected drum kit is transmitted.
Returning Saved Data to the TD-6
This returns settings that have been saved to a sequencer or
other external MIDI device back to the TD-6.
At this time, the TD-6’s data is overwritten. Save any data you
need to an external MIDI device before carrying out this
operation.
Set the Device ID (SETUP/MIDI COMMON/DeviceID; p.
101) used when the bulk data was saved.
1. Use a MIDI cable to connect the TD-6’s MIDI IN
connector to the MIDI OUT connector of the
external sequencer.
fig.07-031.e (IN -> OUT)
2. Send the settings data from the external
sequencer to the TD-6.
The transmitted settings are reproduced.
Content being saved
MIDI OUT MIDI IN
TD-6 External MIDI Sequencer