Ricoh BIZWORKS 106 User Manual
Page 395
87
TROUBLESHOOTING
6. TROUBLE-
SHOOTING
Message
Cause
Remedy
Error Messages (
2
/
4
)
Page
“Memory full” and
“Press Stop”
“Transm.error” and
“Press Stop”
“Too many numbers”
“No connection”
“No loop current”
“Printer in use”
“Machine busy”
Too much sort copy data.
Too many sort copy pages.
An error occurred during
transmission, or the other
line was busy.
If power was lost during the
dialing or connecting
phases of transmission, or
in fax transmission standby
mode, this message will
appear when you next turn
the machine on.
Either the maximum
number of Name Dials have
been stored (25), or you
tried to enter more than 40
digits for a destination fax
number.
The line is busy while dial-
ling , connection failed, you
dialled the wrong number,
or there is no answer.
The line current was not
detected-the line may not
be connected.
The machine is busy print-
ing.
The machine is busy com-
municating.
Press
to cancel sort copying.
If you need to print big copy jobs,
increase the memory capacity.
Press
to print pages al-
ready stored in memory. To can-
cel the job, press
. If you
need to print big copy jobs, in-
crease the memory capacity.
Press
to clear the error
message.
Delete some Name Dials or
enter a shorter number.
When scanning from the ADF,
the machine will automatically
enter redial mode. To cancel
redialling, remove your
document from the ADF.
Check the line connection.
Wait until it has finished and try
again.
Wait until the current operation
has finished and try again.
P.23, 80
P. 23,80
—
P.59
P.52
P.8
—
—
b(GB)6.5_Chapter 06_p82-95
99.8.3, 1:18 PM
87