Ricoh BIZWORKS 106 - Manual (Page 351)

43
FAXING
4. F
AXING
9
Do one of the following:
• If all pages of your document have been scanned
in, go to step 10 .
• If your document contains more than one page,
remove the page from the exposure glass and
set the next page before the counter on the dis-
play reaches zero. Then press or .
Wait until the displays opposite appear and re-
peat this step for all pages in your document.
Note
You have 16 seconds to set the next page. If
you do not set another page, the machine au-
tomatically finishes the transmission.
10
Press # on the numeric keypad to fin-
001-
To enter a pause in a fax number, press .
The pause is shown on the display as a “-”
character.
Set next OK? O K 08
To finish = # 06
ish sending your fax message.
Entering Pauses and Tones in Fax Numbers
You can enter pauses and tones when dialling, or store them in Quick Dial
and Name Dial numbers.
☛ Quick Dials, see page 54.
☛ Name Dials, see page 59.
● Entering Pauses
In some situations, you may need to insert a pause in fax numbers. For
example:
• If your telephone line is behind a PABX (you have to dial an access code to access outside numbers),
insert a pause between the access code and the telephone number.
• For international numbers, enter a pause after the country code.
Set next OK? O K 16
To finish = # 14
Blink
b(GB)6.5_Chapter 04_p40-46 99.8.3, 1:15 PM 43