Ricoh BIZWORKS 106 - Manual (Page 204)

59
TECHNICAL REFERENCE
7.
TECHNICAL
REFERENCE
Selecting Toner Saving Mode
The toner saving mode status has two settings.
3 User param.
02:0000 0 00
Prt Help List O K
1 Press . “Prt Help List” appears.
2 Press or until “3
User Param.” appears. The messages
change in the following order.
1 Tray Pap. Size
3 User Param. 2 Language
3 Press and press to
move the flashing block cursor until it
appears in one of the positions shown
in the illustration to the right.
Note
The bits other than the one highlighted in the
illustration are unrelated to this setting.
4 Press to change the bit setting to
1 or 0, as desired.
Display Heater status
02:0000 0000 Off (Default)
02:0000 0100 On (Density will be lighter)
5 Press . “Please wait”, then “Reg-
istered” appears.
Note
• To cancel this change, press or
instead of . “Please wait”
and “Not Registered” appear on the display.
• Do not turn off the machine while “Please
wait”, “Registered” or “Not Registered”
is displayed.
Please wait
Registered