RCA CC4251 - Manual (Page 39)

37
Playback
Playback Operation and How to Copy Tapes on the VCR
1. A. Camcorder connected directly to
TV: Turn on the TV and tune it to
the video input channel.
B. Camcorder connected to VCR that
is already connected to TV: Turn
on VCR and place it in the “line”
or “camera mode”. (If your VCR
does not have a “line” or “camera
mode”, consult the VCR owner’s
manual.) Operate the TV as you
normally do to see the signal
coming from the VCR.
2. Press and hold the small button on the
CAMERA/OFF/VCR switch while you
slide it to VCR.
Note: The camcorder only plays back
tapes recorded in the SP speed.
Caution: The unauthorized recording of copyrighted
material may infringe the rights of others.
3. Press PLAY.
• During playback, use the playback
features on pages 34-35.
4. To copy what the camcorder is
playing, place a blank cassette in
the VCR, and press the VCR’s
RECORD button.
Note: Make sure the memory-stop feature
is turned off (press DISPLAY) or the
camcorder will enter play-pause when the
counter reaches 0000M.
5. Press STOP/EJECT when you are
finished.
Viewing What the Camcorder is Seeing (or Recording)
1. A. Camcorder connected directly to
TV: Turn on the TV, and tune it to
the video input channel.
B. Camcorder connected to VCR that
is already connected to TV: Turn
on VCR and place it in the “line”
or “camera mode”. (If your VCR
does not have a “line” or “camera
mode”, consult the VCR owner’s
manual.) Operate the TV as you
normally do to see the signal
coming from the VCR.
2. Press and hold the small button on the
CAMERA/OFF/VCR switch while
you slide it to CAMERA.
Note: Turn the TV’s volume down to
prevent a high-pitched squeal caused
by feedback.
3. Press the REC/PAUSE button to begin
recording. You can watch what the
camcorder is seeing (or recording) on
the TV screen.