RCA CC4251 - Manual (Page 33)

31
Recording
Titler (continued)
To Create a Title
1. Attach a power source to the
camcorder. Press and hold the small
button on the CAMERA/OFF/VCR
switch while you set it to CAMERA.
2. Press TITLER to display the titler
graphics in the viewfinder. A flashing
cursor appears.
3. Press EDIT-ADV to move the flashing
cursor to the place you want to begin
your title.
4. Select the first character for your title
by pressing the + or – button until the
character you want appears in the
viewfinder.
See the chart below for the characters
available.
5. After you have selected the first
character, press EDIT-ADV to move
the flashing cursor where you want
the next character to appear.
6. Repeat steps 4 and 5 until you have
completed the title.
7. When you are finished, press TITLER
to store the title and remove the title
graphics from the viewfinder.
Remember: Remove the titler graphics
from the viewfinder for normal recording.
To Correct an Error
1. Press TITLER to display the titler
graphics in the viewfinder.
2. Press EDIT-ADV to move the flashing
cursor over the character you want to
correct.
A B C D E F G H I J K L M
N O P Q R S T U V W X Y Z
0 1 2 3 4 5 6 7 8 9 ?
‘ . / ,
– ; : < > ! (BLANK)
Chart of Characters in Titler’s Register
3. Press the + or – button until the
correct character appears.
Note: If you want to delete a character,
press + or – until the blank space appears.