RCA CC4251 - Manual (Page 13)

Power Your Camcorder
11
Use the Battery to Power Your Camcorder
Charge the Battery
The battery must be charged before it can be used the first time. Initial charging will
take approximately two hours. The camcorder’s operating time depends on how often
you turn the power on and off and how much you use zoom and pause. Conserve
battery power by turning the camcorder off during recording breaks.
Charge the Battery
If the DC cable is attached to the
DC OUTPUT jack on the adapter/charger,
remove it.
1. Align reference mark on battery with
mark on adapter/charger.
2. Hold the battery flush against the
adapter/charger and slide it in the
direction of the arrow.
3. Plug adapter/charger into nearest AC
outlet (120V, 50/60Hz).
4. If the battery is properly connected,
the adapter/charger’s CHARGE
indicator lights.
Note: Your battery will provide better
service if you charge it before and after use
and store it at room temperature.
5. Remove the charged battery by sliding
it up and off the adapter/charger.
6. Attach the charged battery to the
camcorder as shown on the next page.
Caution: When a battery is attached to the adapter/charger, do
not turn them upside down. The battery may fall off and be
damaged or cause injury.
WARNING;
LEAD ACID
BATTERY.
MUST BE
DISPOSED OF
PROPERLY.
To AC 120V,
50/60 Hz
Align
Arrows
Adapter/
Charger
Rechargeable Battery
(Hold battery flush and
slide down.)
CHARGE
Indicator