Regency P42-NG4 - Manual (Page 29)

Regency ® P42-4 Zero Clearance Direct Vent Gas Fireplace 29
INSTALLATION
FULL SCREEN DOORS
2) Remove the Screen Doors from the Full Screen Door Frame by fully
opening the doors and lifting up off of the hinges. See important note
in step 9.
Inside Top
of Outer
Frame
3) Full Screen Door Frame Installation
a) Before attaching the Full Screen Door Frame to the unit, loosen the
left and right side #8 Self Tapping Philips Screws located on the
inside top of the outer frame of the appliance. Also remove the center
screw.
1) Before beginning the installation, remove the Glass Door from the
unit. Refer to the manual for instructions.
Screw
Screw
Screw
Cut-Outs
Bottom
Flange
b) Slide the cut-outs in the Top and Bottom Flange of the Full Screen
Door Frame under the screw heads which were loosened in step
3a. Once the Frame is in place, tighten the screws to secure. Also
re-secure the top center screw through the oblong hole.
Backside of Full
Screen Door
Frame Shown
Cut-Out
Top
Flange
Cut-Out
Oblong Hole
Full Screen
Door Frame