Regency P42-NG4 - Manual (Page 26)

Regency ® P42-4 Zero Clearance Direct Vent Gas Fireplace 26
LOG SET INSTALLATION
INSTALLATION
5) Place the front logs in the unit, aligning the holes on the underside
of the logs with the log support pins in the front of the unit. Carefully
push the logs down onto the pins. (Hint: Install the front right side
fi rst.)
6) Place a few embers under the front logs and a few under the front
part of the burner assembly to make it look like fallen embers.
7) Test for pilot ignition.
8) Install the door and louvers.
Burner tray without
front logs in place
PROPANE
WARNING: Dangerous operating conditions may occur if these logs are not positioned in their correct certifi ed locations. Read the
following instructions carefully and refer to the attached diagram.
NATURAL GAS
IMPORTANT
For Propane Units - only place rockwool and platinum embers
on the rear burner tray behind the burner tube.
The log kit contains the following:
a) Front Right Log
b) Front Left Log
c) Rear log
d) Embers
e) Rockwool
f) Vermiculite
g) Platinum Embers (supplied with packaged manual)
1) Remove the logs from the box and carefully unwrap them. The logs
are fragile, handle with care. Do not force into position.
2) Place the rear log on the rear log support in the back of the unit with
the fl at side of the log facing the back of the unit. Carefully push the
log down onto the pins.
3) Sprinkle the vermiculite on the sides and front of the fi replace bot-
tom being careful not to get any into the air shutter or the burner
ports (burner ports are the little holes in the top of the burner). The
vermiculite is used to cover the sheet metal and hardware on the
fi rebox fl oor and burner assembly.
4) Pull off ember size pieces of rockwool and separate platinum em-
bers and gently place them around the burner. Do not compress the
rockwool or platinum embers, leave it loose for the most realistic
looking embers. Refer to the diagrams below for correct placement
of rockwool and platinum embers on the Natural Gas and Propane
units.
Completed Log Set Installation