Roland RG-3 - Manual (Page 90)

88
Chapter 5. User Program Registration
Using the Pedal to Switch User Programs
You can use the Pedal as a dedicated switch for selecting User Programs in
order.
The User Programs are switched each time the pedal is pressed.
Each press of the pedal takes you to the next higher numbered User
Program until you reach number 36, whereby pressing the pedal again
cycles you back to number 1. (In other words, this sequence: 1, 2, 3, ... 36, 1...)
1.
Press the [Function] (Exit) button, getting its indicator to light.
2.
Press the [Song] (Select -) button or [ ] (Select +) button to
display the USER PROGRAM screen.
fig.05-020d
3.
Press the [Song] (Select -) button or [ ] (Select +) button so that
the “Pedal Shift” is flashing.
fig.05-300d
4.
Press the [ ] (Value -) button or [ ] (Value +) button to
select the pedal to be used for switching the User Programs.
5.
Press the [Function] (Exit) button so the indicator goes out.
The User Programs are switched each time you press the pedal to which the
function of switching performance settings is assigned.
Value Description
Left
The left pedal is dedicated to switching User Programs.
The function assigned to the left pedal cannot be used.
Center
The center pedal is dedicated to switching User Programs.
The function assigned to the center pedal cannot be used.
Off
You can use a function assigned to the pedal.
You cannot use the Pedal as a dedicated switch for selecting
User Programs in order.