Roland RG-3 - Manual (Page 24)

22
Before You Start Playing
Connecting USB Memory
You can connect USB memory (sold separately) to the RG-3’s
Ext Memory port. Connecting external USB memory enables
you to do the following:
• Play back songs stored on the USB memory.
• Save songs recorded on the RG-3 to the USB memory.
• Copy songs in the USB memory to the RG-3’s User
memory, allowing the songs to be called up simply and
easily.
• The images saved to the USB memory are displayed as a
slide show.
• User Programs registered in the RG-3 saved to the USB
memory.
■ Connecting the Memory
NOTE
Always be sure to use the following procedure when
connecting USB memory.
1. Press the Ext Memory port cover at the right of the
RG-3’s bottom panel to open the cover.
Press the front of the cover to open it.
fig.00-0431
2. Connect the USB memory to Ext Memory port.
* Carefully insert the USB memory all the way in—until it is
firmly in place.
fig.00-0440
3. Press on the front part of the Ext Memory port
cover to close the cover.
NOTE
Use USB memory available from Roland. Proper
operation cannot be guaranteed if other external
memory products are used.
Locking the Ext Memory Port Cover
You can lock the Ext Memory port cover to prevent theft of
the USB memory connected to the Ext Memory port.
1. Connect the USB memory (refer to previous
section).
2. Press on the front part of the Ext Memory port
cover to close the cover.
3. Using a screwdriver, remove the anti-theft lock
screws (two screws) to the side of the Ext Memory
port.
fig.00-0450
4. Turn the anti-theft lock as shown in the figure
below so it is oriented in the direction opposite of
that when removed, then tighten the screws.
fig.00-0470
NOTE
Be sure to replace removed screws when securing the
anti-theft lock.
USB Memory