Nortel Networks MOG6xx - Manual (Page 50)

50
WLAN IP Telephony Manager 2245 configuration
3 Reset the WLAN IP Telephony Manager 2245 in order to save the configuration parameters.
Follow the steps in
“Saving the configuration” on page 53 to save the configuration.
Configuring the SVP-II
1 Select SVP-II Configuration from the NetLink SVP-II System menu to configure additional
options for WLAN IP Telephony Manager 2245.
The SVP-II Configuration screen appears (see Figure 5 ).
Figure 5 SVP-II Configuration screen
2 Configure the following fields with information provided by the network administrator:
• Phones per Access Point – enter the number of simultaneous calls supported for the type
of AP. AP specifications are described in
Appendix A: Compatible Access Points on page
77 .
• 802.11 Rate – select Automatic to allow the wireless handset to determine its rate (up to
11Mbit/s). Select 1MB/2MB to limit the transmission rate between the wireless handsets
and APs.
• SVP-II Master – the IP address of the master of the WLAN IP Telephony Manager 2245
group must be identified. Select one of the following identification options:
— Enter the IP address of the master of the WLAN IP Telephony Managers 2245 in each
WLAN IP Telephony Manager 2245 group. Include the periods used in the IP address.
— Enter DHCP. Ensure that the IP address of the master WLAN IP Telephony Manager
2245 has been configured in the DHCP Server and configure the other WLAN IP
Telephony Managers 2245 to obtain the information from the DHCP Server.
— Enter DNS. Ensure that the IP address of the master WLAN IP Telephony Manager
2245 has been configured in the DNS Server and configure the other WLAN IP
Telephony Managers 2245 to retrieve this information from the DNS Server.