Network Technologies SM-nXm-C5AV-LCD - Manual (Page 11)

NTI VEEMUX AUDIO/VIDEO MATRIX SWITCH VIA CAT5
7
Plug-in and Boot Up
1. Plug the power cord from the monitor into the power outlet.
2.
Connect each AC adapter power connector to the 9VDC ports on the Remote and Local Units. Make sure the power
connectors go into each port all the way. Plug each AC adapter into a power outlet. The green LED on the RJ45 connector
of both the Remote and Local Units should illuminate, indicating that a proper power connection has been made to them.
(See Fig. 4.)
Figure 4- Connect the AC adapters
Note: The yellow LED on each RJ45 connector will blink anytime data traffic is passing between the Local and
Remote Units, indicating proper CAT5 cable connection and communication. (See Fig. 4)
Green Power LED
Barrel
(Inside
barrel) (Outside
barrel)
Power Connector
2.1 mm x 5.5 mm Female
9VDC @ 1.0A OUTPUT
Yellow Communication LED
Rear View of Remote/Local Unit
9VDC
1A
- +
Cat 5
Monitor
9 VDC
AC
ADAPTER