Network Technologies SM-nXm-C5AV-LCD - Manual (Page 10)

NTI VEEMUX AUDIO/VIDEO MATRIX SWITCH VIA CAT5
6
The Remote Unit
1. Position the Remote Unit such that the CAT5 cable, the monitor cable, speaker cable, and the AC
adapter power connector can each reach the Remote Unit comfortably.
2. Connect the monitor cable to the female 15HD video connector on the Remote Unit.
3. Connect the speakers to the 3.5mm jack on the Remote Unit (see Fig. 3).
Figure 3- Connect the Extended Components to the Remote Unit
4. Connect the CAT5 cable to the “Cat 5” port on the Remote Unit. (See Fig. 3.) When properly inserted the CAT5 cable end
should snap into place.
Note: If an RJ45 wall outlet is being used, connect the other end of the extension cable to the RJ45
wall outlet.
WARNING: Never connect the ST-C5VA-600 Extender to an Ethernet card, Ethernet router, hub or switch or
other Ethernet RJ45 connector of an Ethernet device. Damage to devices connected to the Ethernet may result.
!
VGA
Multi-Scan
Monitor
15HD Female
Video Connector
ST-C5VA-600 Remote Unit (Front and Rear View)
CAT5 Cable to
VEEMUX
Rear View of Remote Unit
Remote User's Monitor and Speakers
NTI
R
Network Technologies Inc
XTENDEX
- +
Front View of
Remote Unit