NetComm NB6W User Manual

Page 98

NB6, NB6W, NB6Plus4, NB6Plus4W, NB6Plus4Wn

User Guide

YML854Rev1

www.netcomm.com.au

Source IP Address/ Subnet mask/ Port:

Key in the

source IP address (ex.: 192.168.1.0) and subnet mask (ex.: 255.255.255.0) for the

application (ex.: FTP, HTTP, and so on) that you want to invoke the QoS traffic rule. You may simply
enter the

source port, ranging from 0 to 65535, as the traffic condition.

Destination IP/ Subnet mask/ Port:

Enter the

destination IP address (ex.: 168.95.1.88) and subnet mask (ex.:255.255.255.0) for the

application that you want to invoke the QoS traffic rule. Or simply enter the

destination port for the

traffic condition; it ranges from 1 to 65535.

Traffic Priority/ IP Precedence/ IP type of Service/ WAN 802.1p:

Please refer to Bridge QoS.

After you click

Apply, the new QoS setting will be shown below.

According to the example, we set four rules for IP QoS. In traffic A, we set 1-1024 as the

destination port,

and the traffic priority is low; in traffic B, the

source port is from 201 to 8000, and the priority is medium; in

traffic C, when the

source IP is 192.168.1.0, subnet mask is 255.255.255.0, the traffic priority is high; in

traffic D, when the traffic is heading to 168.95.1.88, the priority is high.

To delete the rules you set, simply click the check button below

Delete item and click Delete button.