NetComm NB6W User Manual

Page 79

YML854 Rev1

NB6, NB6W, NB6Plus4, NB6Plus4W, NB6Plus4Wn

User Guide

www.netcomm.com.au

IP Routing – Static Route

The table shows all static route status and allows you to add new static IP route or delete static route. A Static
IP Routing is a manually defined path, which determines the data transmitting route. If your local network is
composed of multiple subnets, you may want to specify a routing path to the routing table.

Destination Network Address:

Display the IP address that the data packets are to be sent.

Netmask, Gateway, WAN Interface:

Display the subnet mask, gateway, and WAN interface information that the transmitting data will
pass through.

Delete:

Allow you to remove the static route settings.

This page shows all the routing table of data packets going through your ADSL Router.

Adding a New One

To add a static route, please click

Add. Type the destination network address, subnet mask and

gateway that you received from the ISP and click

Apply.

IP Address:

The destination IP address of the network indicates where data packets are to be sent. You may
specify an IP, type 0.0.0.0, or leave it blank.

Netmask:

Enter the subnet mask that you got from the ISP, type 0.0.0.0 or leave it blank.

Gateway IP Address:

Click this button to forward packets to the specific gateway. Key in the gateway IP address that you
want to use.

WAN Interface:

Click this button to forward packets to a specific WAN interface. Choose one from the drop-down menu.
E.g., type 192.168.1.1 in the field of the gateway IP address and leave the destination network blank.
Click

Apply to view the routing result.