NetComm NB6W - Manual (Page 39)

YML854 Rev1 NB6, NB6W, NB6Plus4, NB6Plus4W, NB6Plus4Wn NB6, NB6W, NB6Plus4, NB6Plus4W, NB6Plus4Wn User Guide
www.netcomm.com.au
PPP over Ethernet (PPPoE) IP Extension mode
Description:
In this deployment environment, the PPPoE session is between the ADSL WAN interface and BRAS. The ADSL
Router acts as a bridge and gets a public IP address from BRAS for your computer. And only the one that got
the public IP address is allowed to access into Internet. The real IP that you got is acquired from ISP. Moreover,
no NAT translation will be done at this case.
Configuration:
1. Start your browser and type 192.168.1.1 in the URL box to access ADSL web-based manager.
2. Go to Advanced – Internet – Connections. And click Add.
3. Key in the VCI and VPI value, e.g.:
• VPI – 8
• VCI – 35
Click the Next button.
4. On the Configure Internet Connection – Connection Type page, select PPP over Ethernet (PPPoE) then
click the Next button.
5. On the WAN IP Settings page, select Obtain an IP address automatically, check PPP IP extension (and
Enable NAT would become disabled automatically) then click Next.
6. On the PPP Username and Password page, enter the PPP username and password offered by your ISP.
Select Always on, and then click Next.
7. Check the network information on This Internet Connection -- Summary page. Make sure the settings
match the settings provided by the ISP. Click Apply.
8. Press Finish.