Navman iCN 620 User Manual

Page 33

NAVMAN

iCN 620 user manual

To remove the

suction cup, pull the

lever up. Release the

suction

using release tab.

Sucker pad

Suction cup

Lever

Locking nut

Suction or Adhesive Mount to Dash

1 Choose a position on the dash where the iCN 620 will be clearly visible by the driver. Follow the safety guidelines

at the front of this manual to ensure that the unit does not obstruct the view of the driver, or interfere with the
operation of any airbags and safety devices in the vehicle.

2 Make sure that both the dash and the suction cup are thoroughly clean.

3 Suction Mount: if the location you have chosen is flat enough, you can simply use the suction cup to mount the

unit directly onto the dash.

4 Adhesive Mount: If the location you have chosen is not suitable to use the suction cup alone, stick the sucker

pad down first to give a flat surface. Do this by removing the protective layer from the adhesive tape on the
underside of the sucker pad, and pressing the sucker pad firmly down for 30 seconds in the desired position on
the dash.
NOTE: this is a permanent solution the adhesive tape and sucker pad cannot be removed from the dash
once fixed.

5 Hold the suction cup firmly against the dash or centrally on the sucker pad, and press the lever down until it

snaps shut.

6 The ball foot should now be securely fixed. Slip the locking nut loosely over the ball foot, with the flat side

facing upwards.