Navman iCN 620 - Manual (Page 32)

32 NAVMAN iCN 620 user manual
To unclip the iCN 620
unit from the
mounting bracket,
press down on the
back of the upper
plastic clip to release
the top of the unit,
then lift the unit
out of the
bottom two slots.
In vehicles where
auxiliary power is
permanently on, the
unit can be switched
on and programmed
as soon as the
power adaptor is
connected. Switching
the engine on will not
reset the unit.
Aerial points up
and out
10 Flip the aerial outwards so that the aerial is pointing horizontally.
11 Plug the power cable into the socket on the left hand side of the unit.
12 Plug the other end of the power adaptor into the vehicle’s cigarette lighter socket.
13 Make sure that the unit is positioned such that the aerial has a clear view of the sky.
14 In most vehicles, you will need to have the engine idling in order to program your route into the unit. While you
can switch on the unit with just the auxiliary power on (i.e. your key in the Auxiliary ON position), turning the key
to switch on the engine may interrupt power to the unit and your programmed route will be saved for re use. It is
recommended that you program your route with the engine may already idling, but with the automatic shift of your
car in ‘Park’ and the handbrake applied.