Polycom RMX 1000 - Manual (Page 160)

Polycom RMX 1000 User Guide
18-5
Table 18-2 Parameters Description
Parameter Description
ip IP address of the destination host
-n Packet sending times, defaulted to 10
-w Waiting time, defaulted to 1000 ms
-l Size of the sent packet, defaulted to 32 bytes
[Example] Send the host whose IP address is 172.21.100.111 a Ping packet
with the size of 1500 bytes for five times cyclically. The wait time is 1000 ms:
Network Setting
Enter the following commands after the prompt "#" to set network
configurations:
“set {lan1 | lan2} ip {dhcp | static netmask gw }” -
set the IP address for LAN 1 or LAN 2.
“set {lan1 | lan2} speed {auto | 1000 | 100 full | 100 half | 10 full | 10 half}”
- set the connection features for the LAN 1 or LAN2 interface.
Table 18-3 Network Setting Parameters – LAN Interface IP Address
Parameter Description
dhcp
Automatically gets the address information through the DHCP
server.
static
Specifies the static IP address information -
Ip: IP address of the network port
mask: subnet mask of the network port
gateway: gateway address of the network port
Table 18-4 Network Setting Parameters – LAN Interface Connection Rate
Parameter Description
auto Auto negotiation mode
1000 1000Mbps
100 full 100Mbps full duplex