Polycom RMX 1000 - Manual (Page 104)

Polycom RMX 1000 User Guide
11-9
The table below explains the detailed meanings of these parameters.
Table 11-6 Description of Port Settings
Parameter Description
Fixed Ports
Specifies whether to define the TCP and UDP ports.
ƒ Leave this check box clear if you are defining a Network
Service for local calls that does not require configuring a
firewall to accept calls from external entities. When this
option is not selected, the system uses the default port
range.
ƒ If the firewall is incompatible with H.323, enable this
setting and specify the TCP and UDP port ranges.
TCP/UDP Ports from
Shows the default TCP/ UDP port range. The user can set
the start port number here, and the end port number will be
calculated automatically.
If the network administrator does not specify an adequate port range, the system will
accept the settings and issue a warning. Calls will be rejected when the MCU’s ports
are exceeded even if hardware ports are still available on the RMX 1000.
Email
Users can set the address and account information for outgoing conference
notification Emails. In the IP Network Services interface, click Email to
configure the Email information.
Figure 11-8 IP Network Services – Email
Table 11-7 Description of Email Settings
Parameter Description
Email Address
Set the Email address for outgoing Email messages.
SMTP Address
Set the mailbox server address for outgoing Email
messages.