Pitco Frialator Gas Fryers SG Serie - Manual (Page 57)

Pitco Solstice and Solstice Supreme High Efficiency Gas Fryers
L22‐345 R1
57
12. Make sure the temperature bulb(s) are in the
correct location.
13. Reinstall the two (2) bolt clamp screws using a
Phillips screwdriver.
NOTES:
Hi limit and thermostat capillaries should not be
in contact with the heat tubes.
Make sure the bulbs are centered in the bolt
clamp before tightening the screws.
Make sure the thermostat bulb is mounted on the
welded side of the tapping pad.
14. Follow steps 2 through 11 in reverse.
15. Calibrate the thermostat.
Calibrating the Thermostat
1. Remove thermostat knob. 2. Rotate adjustment screw 90 degrees at a time to
match set temperature. Clockwise to decrease
temperature, counter-clockwise to increase
temperature.
3. Replace knob.