Printronix P7000 H-Series User Manual
Programmer’s reference manual
This manual is related to the following products:
Table of contents
Document Outline
- 1 Introduction
- 2 Configuring With The Control Panel
- 3 LinePrinter Plus KSSM Emulation
- KSSM Emulation
- Configuring The KSSM Emulation With Control Codes
- Format For Control Code Descriptions
- Control Code Index
- Advance Print Position Vertically
- Align SBCS Character with DBCS Character
- Cancel The Alignment of SBCS Character With DBCS Character
- Backspace
- Barcode Printing
- Beeper
- Cancel Line
- Carriage Return
- Define Pattern for Special Printing Effect
- Define User-Defined Character
- Define User-Defined Chinese Character
- Delete Last Character in Buffer
- Divided Hangul Double Height
- Enable Printing of Upper Control Codes
- Enable Upper Control Codes
- Font Expansion
- Form Feed
- Graphic Printing
- Graphics Printing: Select Bit Image
- Initialize Printer
- Line Feed
- Master Select
- Master Select In DBCS Mode
- Master Select One-Line Attribute In DBCS Mode
- Pair Two Characters in Vertical Printing
- Reassign Bit-image Mode
- Select 1/6-inch Line Spacing
- Select 1/8-inch Line Spacing
- Select 10 CPI
- Select 12 CPI
- Select 15 CPI
- Select 60-dpi Graphics
- Select 120-dpi Graphics
- Select 120-dpi Graphics
- Select 240-dpi Graphics
- Select an International Character Set
- Select Bit Image
- Select Bold Font
- Cancel Bold Font
- Select Character Style
- Select Character Table
- Select Condensed Printing
- Select Condensed Printing
- Cancel Condensed Printing
- Select DBCS Print Quality
- Select Double-strike Printing
- Cancel Double-strike Printing
- Select Double-width Printing (One Line)
- Cancel Double-width Printing (One Line)
- Cancel Double-width Printing (One Line)
- Select Double-width Printing in DBCS Mode (One Line)
- Cancel Double-width Printing in DBCS Mode (One Line)
- Select DBCS Mode
- Cancel DBCS Mode
- Select Hangul Myunjo/Gothic Style
- Select Italic Font
- Cancel Italic Font
- Select Print Quality
- Select Printer
- Deselect Printer
- Select Superscript/Subscript Printing
- Cancel Superscript/Subscript Printing
- Select DBCS Super/Subscript Printing
- Select Vertical Printing
- Cancel Vertical Printing (Select Horizontal Printing)
- Set n/60-inch Line Spacing
- Set n/180-inch Line Spacing
- Set Absolute Horizontal Print Position
- Set Bottom Margin
- Cancel Bottom Margin
- Set DBCS Character Half Width
- Cancel DBCS Character Half Width and Super/Subscript Printing
- Set Horizontal Tabs
- Set Intercharacter Space
- Set Intercharacter Spacing of DBCS Character (Hangul Extension)
- Set Intercharacter Spacing Of SBCS Character (Hangul Extension)
- Set Left Margin
- Set Page Length In Inches
- Set Page Length In Lines
- Set Relative Horizontal Print Position
- Set Right Margin
- Set Vertical Tab Channels
- Set Vertical Tabs
- Set Vertical Tabs In VFU Channels
- Tab Horizontally
- Tab Vertically
- Turn Auto-wrap Around On/Off
- Turn Double-Height Printing On/Off
- Turn Double-Width, Double-Height Printing On/Off
- Turn Double-Width Printing On/Off
- Turn Extending Table Character On/Off
- Turn On/Off OCRB Selection
- Turn Proportional Mode On/Off
- Turn Underline On/Off
- Turn Underline On/Off (Hangul Extension)
- A Standard ASCII Character Set
- B Code Table
- C Contact Information