Printronix P7000 H-Series - Manual (Page 34)

34
Chapter 3 Configuring The KSSM Emulation With Control Codes
FUNCTION ASCII CODE PAGE
Hangul Extension Commands (continued)
Turn Extending Table Character
On/Off
FS v n 78
Turn Underline On/Off FS - n 80
Superset Command
Barcode Printing SSCC c t 36
Graphics Printing: Select Bit Image SSCC * m nL nH d1…dk 45
Turn On/Off OCRB Printing ASSC 0 z n 78
Define User Defined Character ASSC 0 2 40
Font Expansion ASSC 0 e 43
Graphic Printing ASSC 0 * 44
Master Select One-Line Attribute ASSC 0 ! 49
Advance Print Position Vertically
ASCII Code ESC J n
Hex Code 1B 4A n
Dec Code 27 74 n
Purpose Advances the vertical print position n/180 inch.
Where:
0 <=
n <= 255
Comment This command does not affect the horizontal print position.
Advances paper to the top-of-form position on the next page if
the ESC J command moves the print position below the
bottom-margin position setting.
Align SBCS Character with DBCS Character
ASCII Code FS U
Hex Code 28 85
Dec Code 1C 55
Purpose Aligns two SBCS characters to fit the space normally occupied
by a full-width DBCS character that does not have a half-width,
subscript, or superscript feature.
Comment A DBCS character with half-width, subscript, or superscript
feature is treated as an SBCS character.
The intercharacter space of the next character is set by the FS
S command.
In the default mode, the SBCS character aligns with the DBCS
character.